Search
Search results
-
Cordis CPC Electronic Pressure Controller Troubleshooting Guide
... ring at a high frequency for a short period of time when command signals are varied. - Lower the proportional value until the ... It will also become less sensitive to changes in command, and when exhausting to 0% of command, may close the exhaust valve ...
-
New! Cordis Electronic Flow Controller
... and the Clippard EVP or DVP proportional valve. As command is increased, the comparative circuit opens the valve to allow flow to ... sensor detects a value higher or lower than the setpoint command, the proportional valve will modulate more or less output to maintain a ...
-
Coming Soon! High Volume Cordis Pressure Controller
... an onboard microcontroller, analog and digital Command, ±0.25% accuracy, ~5 to 10 mV resolution—now in a new unit that ... Signal/Command Electrical : 0 to 10 ...
-
Cordis Pressure Controls Selection Guide
... Signal / Command 0 to 10 VDC or Serial ...
-
How to Plumb Clippard's Cordis Pressure Controller for Vacuum
... a 0 to -15 psi or 29” Hg output calibration to a 0-10 VDC command signal, a 10v command will equal full vacuum. The exhaust proportional valve becomes the ...
-
Cordis Flow Controller FAQ
... can be commanded by using voltage, serial or current command. Are there other plumbing options available? A: The Cordis is ... in the field? A: Yes. Refer to the Operations Manual for command sets needed to accomplish this. Can Cordis be calibrated 0 to 5.00 ...
-
Digital vs. Analog Control in Proportional Applications
... to electromagnetic noise. They also facilitate a much richer command set and feedback on process status information. However, digital ... power output to the valves in response to a change in command or operating conditions. Generally speaking, an analog controller will ...
-
Pressure Control vs. Flow Control
... providing feedback to an analog or digital circuit board. A command signal generator (usually a PLC) is used to supply the EPR with a command setpoint. For example, a 0-10 VDC signal (many options exist) directly ...
-
Pressure Sensor Ranges for the Cordis CPC Series Electronic Pressure Regulators
... about it bleeding expensive gases out to atmosphere. Our command capabilities are 0 to 10 VDC, 4-20 mA, and 3.3 volt serial. 3.3 volt ... pressure sensors to choose from, you can now configure your command and output to be as specific as possible in your application ...
-
Cordis CPC Electronic Pressure Controls FAQ
... be made in the field? A: Yes. Refer to the IOM for command sets required to accomplish this. Can Cordis be calibrated 0 to ... of the Cordis unit? A: The Cordis can respond to command signal changes of 5 mV. Tags: ...
